Alfaholics Premium Quality Synchromesh Ring
£110.00 GBP (ex vat)
RCE6008/5
New production - exclusive to Alfaholics. We chose to manufacture these new premium quality synchro rings due to the continuing issues with the reproduction rings currently available on the market. It is common knowledge among Alfa racers round the world that the reproduction rings are not made to the correct tolerances and this leads to baulked gearchanges and premature molybdenum coating wear, particularly noticeable during track and fast road use. Until now there has been no solution to the problem, as only the standard reproduction rings have been available. Up until 10 years ago when the genuine Alfa synchro rings...
High Compression Forged Twin Spark Pistons
£225.00 GBP (ex vat)
RCE4003
85mm Forged Piston, Over 11:1 compression ratio. Pistons pocketed to allow use of new profile Alfaholics race cams & a standard head with no further machining of piston. Comes complete with rings, gudgeon pins & circlips.
Twinspark Piston & Liner Set
£435.00 GBP (ex vat)
ENG4010
High quality piston and liner set for twinspark engines. Includes gudgeon pins, circlips and liner seals.
Inlet Manifold Rubber Joint -Twinsparks and Spider Injection
£7.95 GBP (ex vat)
ENG4018
Short rubber air intake hose that connects between the cross-over air hose and the intake plenum on all Bosch injected Twinspark engines and also Bosch injection Spiders 1988-93. 1 per car, approximately 70mm internal diameter.
8v Twin Spark Inlet Manifold
£355.00 GBP (ex vat)
RCE4011
Convert your 8v Twin Spark engine to run on carburettors or throttle bodies with this inlet manifold. Comes with water temperature sensor point tapped to take 105 series sensor. Casting enables tapping to fit heater hoses if used for road use. Casting also includes pick up point for carburettor throttle quadrant.
RHD Throttle Quadrant Assembly
£79.95 GBP (ex vat)
FUL040
Perfect copy of the factory throttle quadrant setup for all RHD 105/115 series cars. The original components are now nearly all very badly worn on the spindle as well as the ball joints, and this results in significant free play in the throttle mechanism and thus often not achieving anywhere near full throttle with the pedal pressed to the floor! This complete assembly will direct bolt on and has excellent tolerances to ensure no free play in the system - a very simple BHP increase! Also suitable for use with Twinspark engine conversions etc.
Cam Cover Gasket – Twinspark
£20.00 GBP (ex vat)
ENG4006
Premium production cam cover gasket to suit Twinspark engines.
Cam Cover Oil Seal – Twinspark
£2.95 GBP (ex vat)
TS050
Cam cover oil seal- for Alfa 75 and early 164 Twinspark engines - three per engine. Not for 155 version.
Oil Filter – Alfa 75 Twinspark
£7.45 GBP (ex vat)
ENG4020
Spin on small oil filter for Alfa Romeo 75 Twinspark
Billet Aluminium Twinspark Oil Filler Cap
£55.00 GBP (ex vat)
ENG3014/1
Original plastic Twinspark oil filler caps are notorious for cracking, problem fixed with this item!