Crank Sensor Assembly • Nord Retrofit

CNC machined billet aluminium bracket, with 2 wire magnetic sensor. Bespoke design solution to allow simple, durable and accurate mounting of crank position sensor to convert any non-EFI Nord engine to enable the running of modern ECU for either 3-D mapped ignition or EFI ECU management systems.

The bracket mounts to the rev counter drive mounting point on the water pump requiring no secondary brackets or support, the kit comes complete with a shim set to allow the gap from the toothed trigger wheel and the sensor to be finely adjusted to get the desired wave signal amplitude. Designed to be run with Alfas Bosch Motronic 60-2 toothed front pulley, or our billet aluminium variant TWS5287 as used on our Alfaholics-R builds.

Please note that mechanical rev counter output is no longer useable when this is installed. Rev counter needs converting/replacing with electronic unit which can be driven directly from ECU output for greater rev counter accuracy.