Stage 6 - ECU Installed & Engine Bay prepared prior to engine installation

ECU, coil packs and amplifiers installed inside the car under the dashboard. ECU loom wired up, ends individually soldered and shrink wrapped prior to fitting inside multi-plugs.

ECU wiring completed

Wiring loom installed in the car, fuse box repositioned from inner wing to the bulkhead, as originally done in a GTA, maximising inlet space. All terminals cleaned and female ends shrink wrapped

New copper brake lines made up and fitted along with new servo, brake light switch etc. Carrier for resevoir fabricated and painted with 2-pack paint.

Engine bay ready for installation of 8v Twin Spark engine.

Brake lines plumbed through to wheel arch and Earls braided hoses fitted